Dụng Cụ Ngắt Kết Nối Bambu Lab AMS

Due to the way the Bambu Lab AMS Buffer is designed, disconnecting the PTFE tube and the control cable can be difficult. The tube coupler's release ring is recessed inside the buffer, and the cable's release clip is between the cable and the printer's rear case, with only a couple of millimeters between them.

So, I designed these two tools to make it easy to release the tube, and press the cable's release clip, allowing you to quickly and easily disconnect the AMS from the printer.

Disconnecting the AMS isn't something that you'll need to do very often, but when you do, these two tools will make the job a lot easier.

These were designed in Tinkercad, and after much testing and several iterations, I have declared these to be the best.

You can watch the video about them here: