Skip to main content
F3D
Giá Đỡ Băng SNES Cho Kệ Kallax 1

9 images

Dụng Cụ Tiện Ích

Giá Đỡ Băng SNES Cho Kệ Kallax

By CharlesAhrens

Downloads
463
Likes
91
Views
4,372
Remixes
1

Files 3 136 KB

  • Round_1765814171.stlSTL · 48.7 KB
  • Dovetail_1765814172.stlSTL · 1.1 KB
  • 6_Slot_1765814173.stlSTL · 86.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

This is a SNES cartridge holder for NTSC (North America or Japan) cartridges that will fit up 60 cartridges in a (slightly modified) IKEA Kallax cube shelf.

Files

6 Slot - the basic cartridge holder, can hold 6 cartridges

Dovetail - connecting piece for vertical sections

Round - connecting piece for horizontal sections

Modifying the Kallax Shelf

Remove the top wood piece of the shelf, and pull out one vertical section to make a double wide cube, then replace the top piece of wood. There will be some small dowels left behind that stick up where the shelf used to be, but those can be easily cut off. Do not remove the dowels completely, as they are needed for the shelf below that section.

Setting up the 60 Cartridge Holder

Print 10 of the "6 Slot" file, with 10% infill, 0.2 or 0.3 mm layer height, no support, brim or no bed adhesion. This should make a file that takes just less than 200g of filament.

Print 48 of the "Round" pieces and 20 of the "Dovetail" pieces with >10% infill, any other settings. Push 2 of these into each slot between two of the "6 Slot" pieces. You might have to tweak the scale of these to get a tight fit. I had to use a mallet to gently persuade them to fully seat.

You will need to make a setup with 5 wide, 2 high.

10 of these files will print with just under 2 kg of filament, which works out to less than $1 per cartridge space.

Before you put the whole assembly into the Kallax shelf, test each slot with a SNES cartridge to make sure it slides smoothly. You might have to sand a few surfaces to get a nice smooth fit.

Gently push the whole assembly into the double cube section, gently tapping on the thicker sections to push it back until the cartridge holder is in the position you want. If you want the SNES cartridges to be completely flush with the front, it is easy to insert one on the bottom row to check, but_DO NOT HIT ANY CARTRIDGES THAT ARE IN THIS HOLDER_ as the back is only 2 or 3 layers thick and is easily damaged.

Printer Brand:

Monoprice

Printer:

Maker Select

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

10

Filament: Cheap PLA Black

Notes:

Check inside of each slot for any bumps or stringing that will make a tighter fit.

Category: Video Games

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
136 KB
Largest file
86.2 KB

0 comments

See all