Skip to main content
F3D
Giá Đỡ Phấn Nam Châm (Bi-a) 1

12 images

Thể Thao & Ngoài Trời

Giá Đỡ Phấn Nam Châm (Bi-a)

By Yardboy_367387

Downloads
67
Likes
11
Views
575

Files 10 1 MB

  • chalk_holder-bottom-v3_1765796779.stlSTL · 13.2 KB
  • chalk_holder-top-v2_1765796780.stlSTL · 174.3 KB
  • chalk_holder-clip_1765796781.stlSTL · 116.3 KB
  • chalk_holder-top-v1_1765796782.stlSTL · 172.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

3-Piece magnetic chalk holder for billiards. Clip fits over waistband or a pocket.

Printer Brand:

Monoprice

Printer:

Maker Select Plus

Rafts:

No

Supports:

No

Resolution:

.3mm

Infill:

25%

Filament: BamTack PLA (or ABS) Any

Notes:

Top v1 has hole diameter roughly the same as the cube of chalk.

Top v2 has a larger hole for those who prefer it, essentially just the corners, but leaves more visible gaps.

  1. Too big - feels very clunky in the hand compared to a cube of chalk.
  2. Magnet-to-washer attraction is too weak - cube too easily knocked off clip.

As such, I have added a more refined version of Top and Bottom (v3 files). Rather than the bottom being a "tray" holding the chalk, this new top is sized just to fit the cube of chalk, and the new bottom is just a snap-in plate. This smaller size feels much better in the hand (in my opinion).

And, I have replaced the fender washer in the clip with a second 3/4 x 1/16 inch disc magnet, oriented so that it attracts to the magnet on the base of the cube. Much stronger hold, no problems with it falling off now.

Post-Printing

Add magnet and washer

Glue a strong 3/4 x 1/16 inch disc magnet to the bottom of the bottom piece with thick CA or suitable alternative.

Carefully press a second 3/4 x 1/16 inch disc magnet fully into the slot in the clip. Ensure that the magnet is oriented correctly to the magnet on the base of the cube, and do your best to get it centered in the slot.

Put it together

Place a new cube of chalk in the bottom piece, then align the top piece and press together until bottom snaps into place.

Press chalk firmly back through hole to disassemble and replace chalk. For v3 version, you may need to use a tool of some sort, something with a rounded end that fits through the hole, in order to get enough leverage to press the chalk and bottom plate out.

How I Designed This

Autodesk Fusion 360

3 components

v1/v2 holder with clip

v3 holder with clip

Category: Sport & Outdoors

Read more Show less

Print spec

Formats
stepstl
Model files
10
Total size
1 MB
Largest file
179.8 KB

0 comments

See all