
Giá đỡ Thước cặp cho Hệ thống Wall Control
- Downloads
- 484
- Likes
- 94
- Views
- 1,750
- Remixes
- 2
- Comments
- 0
Files 1 159.6 KB
- wc_caliper-open_1765793620.stlSTL · 159.6 KB
Make a variant with AI
Build another version of this model.
Remix versions 2
Giá đỡ thước kẹp điện tử cho hệ DDD Wall ControlByTomasHAVLIK_1551163 · 04/28/2026
Ly treo tường Wall Control (2 kích cỡ)Bymaxelman · 12/15/2025
Details
- Model ID
- #112046
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
Remix of Improved Caliper holder from Thingiverse to use the Wall Control vertical slots instead of the peg holes. This provides a more secure mount since two slots are used without any wasted space.
It uses my double wall control slot base here on Tinkercad. You can use these to make your own versions of wall control mounts.
https://www.tinkercad.com/things/7Eq3AGUzG47
Print instructions
There is no 'ideal' way to print this I could find. Sideways is probably strongest with supports for the slot tabs. I was able to print successfully upside down using small supports , however it took a bit of careful work snapping out the supports without breaking the thin mounts.
Filament:
Prusament PETG Orange. Use PETG or another strong filament. All my initial PLA based prints all snapped after a short period.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 159.6 KB
- Largest file
- 159.6 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-
New -

-

-

-

-


