Skip to main content
F3D
Khối hàn rào chắn tâm 16mm 2in 1

6 images

DIY

Khối hàn rào chắn tâm 16mm 2in

By SsgtStretch_1305558

Downloads
86
Likes
26
Views
971

Files 9 539.1 KB

  • Fence_Block_4x1x2in_16mmMost_Common_1765778520.stlSTL · 38.8 KB
  • Fence_Block_3.8x1x2in_16mm_45Most_Common_1765778521.stlSTL · 167.6 KB
  • Locating_Pin_round_1x2in_16mmMost_Common_1765778522.stlSTL · 31.1 KB
  • Fence_Block_1x1x2in_16mmMost_Common_1765778523.stlSTL · 19.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

These are fencing blocks and locating pins for use on a 2 inch on Center metal Fabrication table with 16 mm holes. Yes they're made of plastic and they will melt if you try and weld too close to them. But they're certainly a lot cheaper than buying the metal ones, and very cheap to replace if they become damaged. Make sure to print with extra wall thickness. Think of this as the super cheap version of Fireball tools.

No cleanup needed they're a little stiff the first time you put them in the table after that they slide in easily and are very rigid. These are plastic and will melt if you weld too close to them it's recommended you use them to locate your metal parts then clamp the metal Parts down and move the fencing blocks as needed.

Rafts:

No

Supports:

No

Resolution:

.3

Infill:

15

Filament: any PLA any

Category: Tools

Read more Show less

Print spec

Formats
stl
Model files
9
Total size
539.1 KB
Largest file
167.6 KB

0 comments

See all