Mẫu Hướng Dẫn Dây Tóc Mini Remix

I swapped out the mounting bracket on the original model for one with 2 ears and mounting holes in line with the flat of the original so that it would print properly.  

I needed something for the filament guides in my drawer filament setup that could let me move the filament spools around without having to remove and re-attach the PTFE guides, and this seemed to fit that bill well.  So I reworked the mounting to be a little more solid than what was there originally and did a few test prints until I found the right settings to get the 4mm PTFE tube in there without having to re-drill in post.

Printed in Amazon Basics PLA, this worked well.

Thanks for a nice original to work from!