Skip to main content
F3D
Kệ treo tai nghe kèm móc phụ 1

6 images

Dụng Cụ Tiện Ích

Kệ treo tai nghe kèm móc phụ

By bluefin66_1146493

Downloads
43
Likes
4
Views
260

Files 2 1.2 MB

  • headphone_hanger_screw_1765760287.stlSTL · 619.4 KB
  • headphone_hanger_1765760288.stlSTL · 627.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#104134
Published

Description

Inspired by 

Made to screw-clamp onto a desk, and added extra hook at the bottom.

Designed for a desktop 25mm thick but the screw should accommodate down to about half of that. 

Designed for headphones, diameter ~150mm and 25mm wide but there is some margin for larger or smaller (see photos).

Designed for 0.3mm tolerance (25.3mm clamp and 0.3mm smaller screw than the hole).  This should work for most, but if the screw is too tight then shrink the screw 1-3% in your slicer and try again.

Printed with 0.2mm layer height; 3 wall loops; and 15% cubic infill.  Use triangle infill on the screw for a stronger screw.

Use supports from build-plate only; and max 20% threshold angle to avoid printing unnecessary supports. I only needed supports under the part that fits over the desktop (see screenshot). 

The screw-hole is tear-shaped so it can be printed upright (notch upwards) without the top of the hole sagging and constricting the screw (maker's muse tip).

Have fun!

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
1.2 MB
Largest file
627.9 KB

0 comments

See all