Giá đỡ cuộn chỉ gắn tường

This filament spool holder is designed to place filament spool at an angle on the wall.

I use this to my Prusa minis to ease the acces to spool change instead of the rollerskate thingy.

Fits up to 75mm wide spools

Print instructions

The 2 parts is designed with a tight fit - so you just push the parts together using a bit of force and there will be no need of screws.

In case of printing with other tolerances than i did - I designed it with the possibility of locking the parts together with a 3mm screw.