Anycubic i3 Mega Reverse Bowden Holder
Một người giữ biến cảm biến Runout Filament của Mega i3 Anycubic thành một thiết lập Bowden ngược
Mô tả
I am currently rebuilding my old Anycubic i3 Mega printer to use a direct drive extruder, so I wanted to turn the filament runout sensor into a reverse bowden setup. This one uses an old model from Thingiverse which I have used on other 3d printers before. Sadly, it has since been deleted, so I am going to upload it alongside the holder here.
You are going to need:
- 2x M3x20mm screws
- 2x M3 nuts
- 2x PC4-M6 Couplers
- 1x Cable Binder
You will need to snip off the magnetic holder from the original runout sensor so that it will fit inside. I managed to do that with a side cutter and some force. You can also reuse the screws that held the original extruder for the holder. Use a cable binder to fix the cable loom so it doesnt flop all over.
You can print it lying flat on one side with minimal supports for the cable loom holder.
Giấy phép
File mô hình
Chưa có bản in nào được khoe. Hãy là người đầu tiên!
Chưa có bình luận nào. Hãy là người đầu tiên!