Tenlog TL3D Pro power supply "housing"

Needs some 3x8mm and 4x8mm screws - watch out that those attached to the powersupply do not reach to far into the powersupply - otherwise one risks a shorted circuit which might even end deadly. For connecting to the mains I reused the original switch and plug. For connecting the printer I used < I printed in PLA with 0.3mm layer height and 20% infill. ##### Room for improvement: The WAGO clips could have more distance The switch could sit tighter The internal cabling should have black/red for -/+ (instead of blue only) The front plate has +/- embedded (by moving it one layer up) - should have printed that in dual color mode