Tiêu đề Công tắc giới hạn cho Elegoo Phecda trục X và Y Tóm t

“limit switches parts.3mf” is a ready prepared Bambuslicer-project including supports etc. If you do not use BambuSlicer, you may use the also included 4 single pieces instead. You may also have a look at my OnShape-project. Beware: it might be a little messy. OnShape-project “LimitSwitch” You need - 2x Micro Switches TIAIHUA 1A 125V (search Amazon for “Mikroschalter”)

• 4x screws M2 x 10 mm
• 4x nuts M2
• 3x screws M3 x 10 mm
• 3x nuts M3
• 2x washer M3
• 2x screws M4 x 12 mm
• 2x JST-Connector, 3-pin, female To mount it on the X axis, it is best to remove the gantry. Then you can slide the nut into the v-groove from the side. To mount it on the Y axis: remove the 2 screws from the frame under the power on button. Fix plate instead with two M4x12 screws. Fix the microswitch to the L-shaped piece and fix this to the plate. For the wiring: - connect C on the switch with G-pin on the board
• connect NO on the switch with S-pin on the board
• The other pins NC and +5V are not used! I took inspiration from these project. You may find additional information there: - https://www.f3d.vn/3d-model/41739-gia-do-endstop-truc-x-cho-may-in-3d-elegoo-phecda
• <>
• https://www.f3d.vn/3d-model/50814-gia-do-cong-tac-gioi-han-cho-mo-hinh-elegoo-phecda
• https://www.f3d.vn/3d-model/35530-cong-tac-gioi-han-cho-may-khac-cat-laser-elegoo-phecda