Dụng Cụ Hỗ Trợ Viết Chữ

The writing spacer has 3 parts:

• Writing mask
• Gliding spacer placed into the bar
• Guiding side ruler

It encourages appropriate letter sizing and spacing between words to improve legibility. The slider is moved along the top bar after each word while the ruler guides the mask down the length of the page keeping alignment.

No supports are needed to print and it should be placed on the bed as pictured. 

The current sizing supports ruled paper or emerging writers who write using large letters. You may modify the sizing on slicer software for college ruled or smaller print. The slider may be set to 7mm wide and the width of the mask can also be adjusted as needed. I've had success with 35mm.

Lefties, I believe can rotate the setup with the ruler placed on the right side of the paper although I've not tested this out.