Đế VESA 75mm Gắn Dưới Cho TBS Source One V4

Summary

This model permits the attachment of anything with a 75x75mm M4 VESA mount.

An example of something that has such a mount is this Raspberry Pi 4B Case (https://www.thingiverse.com/thing:1815268).

FreeCAD model is included, note that some constraints may be a bit fiddly but it should be fully parametric.

In time as time and weather permit I will slowly add mounts to attach to the 75mm x 75mm mounting hard point.

Print Instructions

Any settings will work as the part is designed to be printed as-is.

Photo is of part printed in Black PLA+ from 3D Fillies Australia, 0.4mm nozzle 0.3mm layer heights, 3 perimeters, 3 solid layers top and bottom, 15% infill.

Once printed use CNC Kitchen M4x4 threaded inserts. I recommend drilling out the M4 holes to 4.5mm for ease of assembly.

NOTE: In order to attach this to the TBS Source One V4 frame, you must use approx M3x20mm fasteners in order to engage the threads in the standoffs. Do not use excessive length as the standoffs in the kit are not threaded all the way through.

Optionally use a paint marker to paint the arrow for ease of viewing as shown in the photo.

How it was made

Used FreeCAD to “”reverse engineer"" the DXFs that TBS provide as part of the Source One series to get the dimensions. Of most important note is that whilst the side to side dimensions are always 24mm, the front to center (center of the 30.5x30.5mm stack holes) offset is 35.25 mm where is the rear to center offset is 37.05mm.

Changelog

• 28 Dec 2023 - Published Printable
• 28 Dec 2023 - Changed license from CC BY SA to GPL v3 to align with the license of the TBS Source One V4