Giá Đỡ Spool Gắn Trên Cho Bambu Lab P1P/S

I really liked the spool holder https://www.printables.com/model/381648-bambu-p1p-carbon-top-filament-spool-holder.
But I added the Bambu walls and back only from the P1S to my P1P's, this meant there was a raised area not accounted for in the original design, the mounting screws didn't line up.

Rather than trying to cut the plates and rear, I simply added a slot to the original design for that purpose, this will work on a P1S BUT not with the glass on.
If you print with the glass off it won't make a difference to you, i.e PLA, PETG.

I printed in PETG 
No raft, support or brim,
5 Walls Bottom and Top
30% infill.

A tip check to make sure the filament flows though before you pop in on, one of mine had a bit of stuck filament in it.