Giá đỡ ống dây tóc và cáp cho FLSUN V400

Holder for filament tube and cable of the FLSUN V400.

Udate: There is now also a sleeve-version available which fits well if one get rid of the friggin “protection”-hose! Prints well without supports, brims might be helpful.

Sits nice on the hexagon fitting on top of the extruder. It should sit quite tight, so there is a tight and tighter version available.

Also a short and a long funnel for the tube. One might decide which looks nicer, just on top of the tube or theone going into the guide.

As always, especially with FDM, there might (will) be differences in diameters depending on how well a printer is dialed in.

The dimensions fit very well with my set-up. Others probably might have to rework and adjust some.