Skip to main content
F3D
Pat Gắn Borescope Tương Thích Satsana 1

2 images

Máy In 3D

Pat Gắn Borescope Tương Thích Satsana

By astrovore

Downloads
23
Likes
2
Views
306

Files 2 284.2 KB

  • ScopeMount-V2_1765730080.stlSTL · 16.9 KB
  • ScopeMount-V1_1765730081.stlSTL · 267.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

These brackets are designed to allow you to securely mount an 8mm USB borescope to a Satsana fan shroud, pointing at the nozzle. I found existing solutions to be too flimsy for my taste so these are deliberately beefed up.

The specific model of borescope I use this with can be found here, although any with an 8mm barrel should work: https://www.aliexpress.com/item/32967094275.html

V1 can be glued under the front of the part cooling duct. It places the scope very close to the nozzle.

In fact, I found this to be too close.

V2 glues to the front of the duct instead allowing you to mount the scope further back. This version has the added benefit of letting you adjust the height at which you mount the scope.

The scope push-fits into the bracket. If you find the fit too loose then you can apply a layer or two of tape around the barrel of the scope until it fits snugly.

Both versions angle the scope 10° from the horizontal and have plenty of clearance assuming you aim it such that the nozzle occupies the centre of the camera's frame.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
284.2 KB
Largest file
267.4 KB

0 comments

See all