Skip to main content
F3D
Kiểm tra góc nhô cho RepRap/RapMan/RepStrap 1

7 images

DIY

Kiểm tra góc nhô cho RepRap/RapMan/RepStrap

By arhi_585078

Downloads
24
Views
168

Files 3 3 MB

  • test_overhang1_1765708910.stlSTL · 2.2 MB
  • test_overhang_top_1765708911.stlSTL · 764.8 KB
  • test_overhang_flat_1765708912.stlSTL · 6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

The simple object to test the maximum overhang 3D printer can deal with. The angles are, top to bottom:

90°

80°

90°

70°

90°

60°

90°

180°

90°

55°

90°

50°

90°

45°

90°

40°

90°

35°

90°

30°

90°

In short, the bottom part is 80,70,60 that should work on every machine and the top part is 55-30 in 5° steps so you can then find what overhead angles you can "live with", what the "good" ones are and what angles are unprintable.

I have now added also a test_overhang_flat.stl after imho valid comment that overhang on the round and flat surface is not same, so here's the one to test the flat overhang.

One side (right) is 60, 55, 50, 45° (with 90° in between) and other side (left) is 40,35,30,25,20° (with 90° in between).

Instructions

Print the object - without support

There is also stl with only "TOP" part that is problematic so with overhang below 60° if you do not want to print the whole object as you know machine will work ok with up to 60°.

Category: Other

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
3 MB
Largest file
2.2 MB

0 comments

See all