Hnefatafl Du Lịch

Just a simple portable Hnefatafl set!  I printed the board itself on low quality (0.28mm, 10% infill) because it is a bit demanding (~48g, ~5 hours), but I tried to skeletonize the rest of the pieces as much as possible and printed them on standard (0.2mm, 15% infill [propbably irrelevant :P]). The lid was ~18g and an hour and forty minutes (vase mode, 100% scale NOT 101%, 0.8mm floor), the pieces take under half an hour and 5g for all of them!

I recommend printing the lid and the board with a brim. It's a long time corner to corner when filling in the first 2 layers, and the border has a long time to warp!

My lid fits right to the bottom of the board, I like that security so the little pieces don't go missing! If you want more room to grip, turn off symmetrical scaling and then reduce the height of the lid by 1mm!

4mm nozzle and PLA used!