
Báng súng IWB Tuckable Holster C-Clip V2 (và V1)
- Downloads
- 277
- Likes
- 47
- Views
- 2,296
- Remixes
- 0
- Comments
- 1
Files 5 2.4 MB
- clip-c-1_V2_1766172988.STLSTL · 442.2 KB
- clip-c-2_V2_1766172989.STLSTL · 530.5 KB
- clip-c-4_V2_1766172990.STLSTL · 399 KB
- clip-c-2_1766172991.STLSTL · 490.1 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #7910
- Category
- Thể Thao & Ngoài Trời
- Published
Description
Less noticeable than an over the belt clip. Better support than a J-clip.
Three lengths included. I like the shorter ones for subcompacts.
Fits 1.5 inch belt.
And after a few iterations and several months testing we have – Version 2!
V2 changes (7-16-2023):
- Added an offset from the mounting screw hole(s) to the over-the-pant riser. Makes tucking a shirt easier and/or clears the screw heads above the mounting screw. Unlike adding a spacer, longer screws are not needed.
- Reduced the width for the belt a bit. Fits with a little less clearance so stays in place better.
- Widened the over-the-pant gap very slightly to accommodate denim pants with double hemmed or reinforced tops (popular on carpenter-style jeans).
- Replaced some of the rounds with chamfers or truncated rounds to print more cleanly.
- Added a one hole clip by popular demand. (Well, it was popular when I demanded it….)
Old version 1 clips are still available for download, too.
Print Settings
Printer Brand:
Creality
Printer:
CR-10 V2
Rafts:
Doesn't Matter
Supports:
No
Infill:
99-100% Concentric
Filament:
Hatchbox/Overture PETG
Black
Notes:
For maximum strength print on its side, with the points of the holes up. The holes will print cleanly without any supports.
I usually print PETG with a raft but also had successful prints in PLA without one.
PLA works but I like PETG for the temperature resistance in case it ends up in a hot car or trunk.
How I Designed This
Reverse engineered a Crossbreed J-clip, Added a top retainer, narrowed up the over the pant clearance, and optimized for FDM printing.
Category: Sport & Outdoors
Print spec
- Formats
- stl
- Model files
- 5
- Total size
- 2.4 MB
- Largest file
- 644.7 KB
1 comment
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-

-

-

-


