HexScraper - Dụng cụ cạo kính chắn gió đa năng

Hello!
I would like to start by saying that this is the first design that I publicly share, so feedback is welcome.
I present you, The HexScraper - A multifunctional windshield scraper.

Designed to be useful to most drivers, it has hex nut cut-outs for the most common sizes found on cars, 8, 10, 13,  and 17mm.

With an ice or snow throw-back design, to keep our hands as warm as possible while defrosting, and leaving a clean trail behind, thus if we go from top to bottom, we get a clean scrape with no leftover.

Made it two sizes, one bigger, more robust, with a handle to provide more grip and torque on the task, be it defrosting or tightening / untightening a nut, and one smaller, more portable and versatile, whilst still keeping the initial vision.

*DISCLAIMER:
The scraping has not been tested, so feedback is welcome. (Did not have a frosted windshield yet)
The hex nuts work good in my testing.

Print Suggestions:
From my testing, I've only tried PLA:
0.15mm Layer Height
20% standard infill