
Prusa MK4 - Con lăn Y làm bộ căng dây đai
Remix of Các bộ phận có thể in được cho MK4/MK3.9 By F3D Team
- Downloads
- 144
- Likes
- 19
- Views
- 1,405
- Remixes
- 0
- Comments
- 0
Files 1 180.2 KB
- MK4_Y_idler-tensioner_1766003640.stlSTL · 180.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #73948
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v2.0
Description
I don't like the need to flip the printer on its side to be able to change belt tension, and the tensioner attached to Y carriage is not easily reachable. Instead, I decided to use the idler for adjusting belt tension. However, the existing idler would allow only 1-2mm of range for tensioning (I'm thinking about future, if the belt gets significantly looser).
I've changed the Prusa's Y idler by extending holes to be able to use longer screws. I've cut the belt for two teeth, tensioned the under-carriage tensioner as much as possible, then I've attached the new idler and adjusted the belt tension using it. Now it's easy to adjust belt tension using the provided hex key, reaching above and below the LCD screen. If needed to remove the belt for whatever reason (some repairs for example), it's easy now: just unscrew the two screws on the idler (no need to flip the whole printer).
Screws required: two M3x16 (or M3x18, I think those would be fine too)
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 180.2 KB
- Largest file
- 180.2 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-
New -

-

-

-

-


