Skip to main content
F3D
Cổng kết nối tín hiệu Mitsubishi Outlander REMCU 1

7 images

DIY

Cổng kết nối tín hiệu Mitsubishi Outlander REMCU

By crasbe_360778

Downloads
23
Likes
10
Views
354
Comments
1

Files 9 5.1 MB

  • Outlander_Signal_Gland_M16_v4_1765788622.3mf3MF · 368.8 KB
  • Outlander_Signal_Gland_M16_v4_1765788623.stlSTL · 1.2 MB
  • Outlander_Signal_Gland_M16_v4_1765788624.stepSTEP · 439.3 KB
  • Outlander_Signal_Gland_M20_v4_1765788625.3mf3MF · 366.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This gland can be used for the Signal cables

Versions

  • M16: For small diameter cables or Bulgin PX connector (or similar).
  • M20: For larger diameter cables.
  • Waipu SP21: If you want to replace the original connector with a 7- or 9-pin Waipu SP21 connector.

Recommended Material & Print Settings

  • 0.1mm Layer height for good thread resolution
  • The M16x1.5/M20x1.5 thread can be tight if there is too much extrusion
  • The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
  • The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

Additional Hardware

  • 26x3mm O-Ring
  • M16/M20 cable gland or Bulgin PX connector

For Waipu SP21 only:

  • 2x M3 heat set inserts
  • 2x M3x8 screws

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.

Read more Show less

Print spec

Formats
3mfstepstl
Model files
9
Total size
5.1 MB
Largest file
1.2 MB

1 comment

See all