Skip to main content
F3D
Baton CoreXY - Máy in 3D giá rẻ 1

14 images

Máy In 3D

Baton CoreXY - Máy in 3D giá rẻ

By FarazKhan

Downloads
124
Likes
36
Views
1,575
Comments
1

Files 1 138.2 MB

  • Baton_CoreXY_-_2023-11-21_1755161205.stepSTEP · 138.2 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#69410
Category
Máy In 3D
Published

Description

This is a cost-effective & minimal design fully enclosed printer; capable of 600mm/s at 30K acceleration and reaching upto 50c chamber temperature. Bill of Materials (BOM) stands at $260, which is quite reasonable.

I have tested printing speed up to 400mm/s at 15K acceleration but its not limited to this. You can go higher with LGX type extruders or maybe tune Sherpa Micro which I have used.

This printer draws inspiration from the Panda Mini and The100 printers in its design. 

I'm using off-the-shelf parts, including standard 2020 extrusion sizes of 300 and 400, eliminating the need for tapping or drilling.

All parts are designed to be printed without requiring support except X gantry mount. You should have a printer with at least a 220x180 build area to accommodate the print bed.

For the bed, this printer utilizes a aluminum or glass bed with a silicone heating pad, although a custom aluminum bed will be best.

The toolhead is a Rapid Burner v7 with a modified volcano mount taken from Dragon Burner.

BOM should include all the necessary parts to build the printer. I'm here to gather feedback and make improvements.

Note: I printed these parts on my calibrated Neptune 3 Pro. Tolerances for linear rod & linear bearing are 8.1mm & 15.1mm about 0.1mm respectively. However Polymer bearings for XY requires no tolerances.

Specs

  • 220x180x150 Build Volume
  • CHC Volcano Pro Hotend
  • Fully Enclosed
  • Linear Rods
  • Klipper
  • Rapid Burner v7 with modified groove volcano mount (taken from Dragon Burner)
  • Sherpa Micro
  • Sensorless homing on all axes.

Links

Update 2023-09-26

Enclosure is done now, I will move to electronics. BOM is not update for enclosure.

Update 2023-09-27

Complete electronics & spool holder done. BOM also updated for enclosure.

Update 2023-11-21

Its completed and printing at 400mm/s at 15K just fine. I have gone for Rapid Burner toolhead, now you can print flexible as well. Also I have opted for aluminum bed instead of glass and using frost glass surface with glue stick for best ABS adhesion.

Read more Show less

Print spec

Formats
step
Model files
1
Total size
138.2 MB
Largest file
138.2 MB

1 comment

See all