Bộ Công Cụ Cho Vườn ZEN (3D In)

Here you go! 

A mix and match tool set for your small ZEN garden. 

The tool heads can be printed without support. The handles are supposed to be printed  with support. 

The small oval, which interfaces with the tool head, needs support and should be oriented upright.

I printed the parts on my X1C and MK3S+ with  layer hight of 1,2mm and standard support with eSun PLA+.

To connect the parts, just push the small oval into the interface of the tool head.

Then heat up the tip of the small oval, e.g. with a lighter, and press the preheated tip firmly with a metal part, e.g. the handle of a spoon.

Be carfeful that you don't hurt yourself and the heat source only heats up the tip and not the tool head.

Happy printing and enjoy yourself with your ZEN garden.

An IKEA SANNAHED picture frame is a good basis to create your own DIY ZEN garden.