Skip to main content
F3D
ESP32 Box and lid + vented + outdoor version, for BME280 1
ESP32 Box and lid + vented + outdoor version, for BME280 1
1 / 5

5 images

DIY

ESP32 Box and lid + vented + outdoor version, for BME280

By mariusbach_1431080

Downloads
75
Likes
8
Views
687
Download all (.zip)· 5 files · 500.4 KB· 500.4 KB

Files 5 500.4 KB

  • ESP32_box_1765721390.stlSTL · 35.5 KB
  • ESP32_lid_1765721391.stlSTL · 134.1 KB
  • ESP32_lid_outdoor_vented_1765721391.stlSTL · 123.2 KB
  • ESP32_outdoor_cover_1765721392.stlSTL · 20.7 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#63827
Category
DIY
Published

Description

Box and lid for ESP32 modules (NodeMCU boards and similars).

The BME280 version offers a mount point for the sensor below the main board. Also, the box then has vents. However, testing revealed that the board gets so warm that the sensor readings are way off (living room 38degC...). Another version with a further separated sensor position will follow at some point.

The outdoor version has no holes for the buttons and LEDs and offers a little roof (to be glued onto the lid) for a better rain protection plus a micro-usb-plug protection. This design is not waterproof, so use at own risk.

Category: Electronics

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
500.4 KB
Largest file
186.9 KB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy