Skip to main content
F3D
Vỏ Case Mini-STX cho Main Asus H110S1 và H110S1/CSM 1

5 images

Dụng Cụ Tiện Ích

Vỏ Case Mini-STX cho Main Asus H110S1 và H110S1/CSM

By muadib_176340

Downloads
50
Likes
6
Views
352

Files 10 6.8 MB

  • H110_S1_unten_Final_1765611449.3mf3MF · 630.6 KB
  • H110_S1_oben_Final_v9_1765611450.3mf3MF · 810.8 KB
  • Schaltblende_Final_1765611451.3mf3MF · 247.9 KB
  • H110_S1_Fu_Final_1765611452.3mf3MF · 295.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#63762
Published

Description

Deutsch:

Da ich nirgendwo ein Mini-STX Gehäuse gefunden habe, musste ich es selber erstellen.

Mini-STX Form Factor: 5.5 in. x 5.8 in. / 14.0 cm x 14.7 cm

Der originale Intel Lüfter war mir zu hoch, deshalb trennte ich den Lüfter ab und befestigte einen kleineren Lüfter mit Klettband. Betreibe den PC mit einem Celeron. 

H110 S1 Fuß Final 4 mal drucken, seitliches Gitter Final 2 mal drucken, der Rest 1 mal drucken.

Zusätzlich erforderlich 4 Schrauben  M4 x 25 mm, nicht zu feste anziehen je nach Filament.

1 Taster mit 12 mm Durchmesser

Änderung H110 S1 oben Final  zu  H110 S1 oben Final v9

english:

Since I couldn't find a Mini-STX case anywhere, I had to build it myself. 

Mini-STX Form Factor: 5.5 in. x 5.8 in. / 14.0 cm x 14.7 cm 

The original Intel fan was too high for me, so I disconnected the fan and attached a smaller fan with Velcro. Run your PC with a Celeron.

H110 S1 Foot Final 4 times, Side Grid Final 2 times, rest print 1 time. In addition, required 4 screws M4 x 25 mm, not too tight depending on the filament.

1 switch with a diameter of 12 mm

Change H110 S1 top Final to H110 S1 top Final v9

Read more Show less

Print spec

Formats
3mff3d
Model files
10
Total size
6.8 MB
Largest file
3.1 MB

0 comments

See all