Bao da súng Ruger Mark IV 22/45 Tactical

This is specifically for the 22/45 Tactical with/without a red dot; I do not know if it will fit a standard Mk IV.

My print settings:

Filament: PLA+
Nozzle: 0.6mm
Layer Height: 0.3
Line Width: 0.6mm
Walls: 4
Top/Bottom: 4
Supports: Only for holster
Infill: 15%

You will need a few bits to put the two together.  I used 2 M4x8 countersunk screws for the belt clip, with heat inserts on the holster side.  The screws are slightly long (M4x6 might be better) so i put washers between the belt clip and holster to add space.