Skip to main content
F3D
Logo Xe Hybrid & EV (Xe Điện) 1

9 images

DIY

Logo Xe Hybrid & EV (Xe Điện)

By SpicyLimes_1046045

Downloads
56
Likes
3
Views
347

Files 4 527.1 KB

  • Hybrid_Emblem_Magnetic-Backing_1766179202.stlSTL · 253.7 KB
  • Hybrid_Emblem_Text_1766179203.stlSTL · 146.4 KB
  • EV_Emblem_Text_1766179204.stlSTL · 3.4 KB
  • EV_Emblem_Magnetic-Backing_1766179205.stlSTL · 123.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I designed these car badges / emblems for a friend's Volkswagen. The Hybrid Badge font is actually the one that Volkswagen uses for their factory badges, and the EV Badge font is a custom font that I found on 'DaFont.com'.

Both of the 'backing' files have small holes on the back so you can add 5x3mm or 6x3mm coin magnets, allowing you to temporary (or permanently) attach these emblems to your vehicle.

The Hybrid Badge text was modified to snap-fit onto the magnetic polygon backing plate. Depending on your printer, you might have to scale it up to 105% or less to allow a little wiggle-room (although I did not have to - they snapped right into place).

Magnets: 6x3mm or 5x3mm Coin Magnets

----------------------------------------------------------------

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

No

Resolution:

0.16mm

Infill: 

20% or More

Filament: SUNLU PETG Black, Red, Green

Notes:

Because these models will be magnetically attached to your vehicle, I highly suggest PETG or another heat-resistant filament. I live in Texas and recently we had a pretty bad heat wave, however the PETG material has held up pretty well so far.

Depending on your printer, you can get away without using supports for the magnet slots on the backs of the 'xxxx\_Magnetic-Backing' models. I did not have to use supports, but if your settings aren't tuned right, you might have a birds nest in those slots after printing.

Category: Automotive

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
527.1 KB
Largest file
253.7 KB

0 comments

See all