Skip to main content
F3D
CanaKit Noctua Fan Replacement Lid 1
CanaKit Noctua Fan Replacement Lid 1
1 / 5

5 images

DIY

CanaKit Noctua Fan Replacement Lid

By RyansBuilds_439218

Downloads
27
Likes
4
Views
298
Download all (.zip)· 2 files · 500.1 KB· 500.1 KB

Files 2 500.1 KB

  • canakit_lid_1767838658.stlSTL · 376.5 KB
  • canakit_washers_1767838659.stlSTL · 123.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#60432
Category
DIY
Published

Description

Description:

Replacement lid for the CanaKit Raspberry Pi 4 Starter Kit to fit a Noctua NF-A8 5V fan. The original fan failed and was always a little noisy. The Noctua is a great replacement but wouldn't fit the original CanaKit case lid.

Notes:

CanaKit Raspberry Pi 4 Starter Kit

  • Purchased on December 20, 2020.
  • Part Number: 99467

Noctua 40x10mm Fan

  • Purchased on November 29, 2022
  • Part Number: NF-A4x10 5V

Assembly:

In order to attached the fan and maintain a low profile four insert washers were used that flush fit into the fan mounting holes. Four M1.4 8mm countersunk screws were used to hold the washers and fan in place. See pictures for reference.

Print Instructions:

Both the lid and washers can be printed with no supports. Below are the settings I used with my prints.

Material

PLA

Nozzle

0.4mm

Layer Height

0.2mm

Infill

50%

Supports

None

Brim

None

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
500.1 KB
Largest file
376.5 KB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy