SOVOL SV06 Filament Sensor Mount

This sensor mount is supposed to hold my filament sensor to the top of the SV06 using the same mounting points as the spool holder. The sensor mentioned also works with the SV06 Plus but without this custom mount.

The filament sensor can be found here: https://www.printables.com/model/579598-sovol-sv06-plus-filament-sensor-replacement

You will need two M4 heat press inserts for the sensor mount. Alternatively you might change the part to use screws only that thread into the plastic.

Print in any material at 0.2mm layer height.

No supports needed. print on the flat arm backside.