Tua vít mini 1/4" có chỗ chứa đầu vít

This model is inspired (not a remix, since it's modeled from the ground up) by Tony Tsay's Customizable bit holder and screw driver, but with a few improvements over the original idea:

• Better tolerance for ¼" bits
   
• Being able to place a 6x2mm neodimium magnet at the bottom of the main bit hole
   
• Make better use of the “real estate” taken by the handle, so it is hollow with a screw-in lid, thus effectively turning it into a storage space
   
• Better grip, so the handle is textured
   
• Still be compact and useful
   
• Stay upright with the lid on or off
   
• Easy to print

The nice thing about this model is that the storage at the handle. 

Suggested printing tips:

• PLA or PETG
• 0.12mm to 0.16mm layer height, for better resistance
• >35% infill, octet (also for better resistance)
• the body/handle does not require supports for printing
• the lid may require support, but since it is a quite small part, it will use minimal support. 
• if using CURA, use the following settings:
  • Wall Ordering: Inside to Outside
  • Use Adaptative Layers 
  • Slicing Tolerance: Exclusive
  • Walls: ≥ 3

If you enjoyed this model, like it and post your make!