Chậu cây tự tưới nước V1

Automatic Watering SystemFlower Pot Model - Enhanced compared to others available on the platform, it waters better, personally tested on my own flowers and windowsill. So, please read the instructions below.

The base dimensions of the working area required to print from the STL file without scaling: 250mm x 250mm x 250mm, although you can simply scale it if you want to switch, for example, from bamboo x1c to cobra 2.

Part 1= Insert into which we pour pebbles or a separator (those granules, unfortunately, I can't remember the name), then soil with the plant. Print on a minimum of 3 walls and 3 top and bottom layers, with 20% infill.

Part 2 = The base of the pot, which serves as a water reservoir. Here, I recommend a minimum of 5 walls and the same number of top and bottom layers.

Part 3 = Water level indicator, two top and bottom layers, and two walls are sufficient, with as little infill as possible. This must float evenly with the water and show us its level. Insert it into the smallest opening in Part 2, of course, when the plant is already in place, and you're pouring water. Haha.

IN CASE OF A SMALLER WORKING AREA - PLEASE RESCALE OR ADJUST THE DIMENSIONS DIRECTLY IN FUSION (I'M ATTACHING A 3MF FILE).