Dây xích cáp 20x10 cho máy in 3D Ender 3

I am running my electronics outside an enclosure, I have a 20x10 cable chain.  I am running this (printed with CF/PETG) as a way to use the extra cable chain I have to run all those misc cables such as Dual Z motor, Z endstop, Y motor/endstop, and I forget what else.

sorry for the bad picture, the model is updated with a 15 degree angle so it comes closer to my additional cable chain mounting for direct drive enders with this.  If you want to run your psu/electronics box outside of the enclosure and away from the heated bed at least, this works well.  Instructions, good luck bolting on the front and side bolt, I have an area to loop in the cables - ***Screw on the end of the cable chain beforehand **** - put on rest of cable chain, enjoy a cleaner situation.