Giá đỡ sonic pad cho máy in 3D CR10 Max Creality

Sonic pad holder for a CR10-Max

Uses the front two M3 holes that holds the bottom plate.

You will need to source two M3x12 bolts, the original bolts aren't long enough

Prints fine with no support.
You might have to remove a small string of filament in the countersunk holes when the part is done.

Mount the sonic pad and tighten the two bolts in the arms so it stays at the angle you want.
Remember to check that the bed clears if you want the sonic pad at a steeper angle