
Kẹp cuộn filament từ kẹp binder 19mm
- Downloads
- 46
- Likes
- 11
- Views
- 406
- Remixes
- 1
- Comments
- 0
Files 3 745.1 KB
- filament_clip_from_binder_clip_1768199519.stepSTEP · 85.9 KB
- filament_clip_from_binder_clip_1768199520.f3dF3D · 203.1 KB
- filament_clip_from_binder_clip_1768199521.stlSTL · 456.1 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #51806
- Category
- Máy In 3D
- Published
Description
This is a new take on a spool clip for keeping the loose end of your filament spools from coming free and getting all tangled up. It attaches to a common size of binder clip, usually labeled as “small” and measuring 19mm wide.
I included an STL, STEP, and Fusion 360 file so you can customize the design if desired.
Note that they are designed to print with the two small pegs sitting on the bed. This doesn't provide a lot of surface to adhere to, but so far it has printed successfully for me. You could clean your bed or use glue stick as appropriate for your printer if they come loose. Either way, I'd suggest keeping an eye on it while printing to watch for any trouble.
Once assembled to a binder clip, just push the loose end of the filament through the little hole, and then clip it to the side of your spool.
I hope you find them useful!
Print spec
- Formats
- f3dstepstl
- Model files
- 3
- Total size
- 745.1 KB
- Largest file
- 456.1 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -

-

-
New -

-

-

-

-



