Chậu cây Voronoi và đế kèm theo

In the ongoing saga of learning Fusion 360, I wanted to figure out how to wrap a SVG around a curve for extrusion and seeing that my better half needed a couple pots for house plants the idea was a win/win.

I printed this at 75% scale in X&Y. Keep the Z Axis for the base/coaster at 100% to ensure that it properly holds the pot in place. You can scale the Z of the Pot if you choose or need to for print size.

There are 9 5mm holes at the bottom of the pot for drainage. You should place a layer of stones at the bottom - about an inch thick and then your potting soil and plants to help with proper drainage and watering.

If you print this please - leave comments, constructive criticism and makes – I am learning as much from my mistakes as from people's comments and critiques.

Printing

You can print this just about however you want. It is pretty tolerant. I uses 4 walls, 10% Gyroid infill and no brim. For the coaster I did bump the Bottom/Top layers to 5 each and applied a bit of water proofing to the inside – just to be safe