
Khóa cài gia cố nặng cho QUICK-CLIP v3
- Downloads
- 852
- Likes
- 160
- Views
- 2,381
- Remixes
- 0
- Comments
- 6
Files 2 329.5 KB
- QUICK-CLIP_-_Reinforced_Perpendicular_Buckle_1766340291.stlSTL · 157.7 KB
- QUICK-CLIP_-_Reinforced_Parallel_Buckle_1766340292.stlSTL · 171.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #49986
- Category
- DIY
- Published
Description
NOTE:This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"
Post-Processing Difficulty:Easy (Ready to Use from Printer)
Tools Needed: None
Introduction & Instructions:
QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a set of reinforced buckles that I designed to go with the base starter set (found under my profile). Module clips are attached to and removed from them in the same way as the other buckles.
These were designed to be more resilient in high-wear positions that experience a lot of flexing, which can break the standard buckles in the starter set.
I printed it with 0.16mm layer lines with PLA with no supports or brims.
Hope you enjoy!
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 329.5 KB
- Largest file
- 171.8 KB
6 comments
You may also like 12 models
See all-

-
New -
New -
New -

-

-

-

-

-
New -

-


