
Công cụ nối filament 1.75mm cho máy in 3D
- Downloads
- 235
- Likes
- 17
- Views
- 1,126
- Remixes
- 0
- Comments
- 2
Files 2 71.6 KB
- filament_splicer_L_1765600183.stlSTL · 29.4 KB
- filament_splicer_R_1765600186.stlSTL · 42.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #49284
- Category
- Máy In 3D
- Published
Description
It never fails.
I always seem to have a partial spool of filament that isn't enough to do a project with.
This is my attempt at using all my partial reels of filament.
You simply clamp the two pieces together and slide a piece of filament in from each end of the tool then place both ends against a soldering iron. Once the filament becomes fluid push one end of the filament into the other and allow it to slide back into the body of the tool to cool.
Clean up any bulge at the joint with hobby knife, razor blade, sandpaper, etc… and load it into your machine.
I printed this tool from PLA with my standard settings.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 71.6 KB
- Largest file
- 42.2 KB
2 comments
You may also like 12 models
See all-

-

-
New -
New -

-
New -

-

-

-

-

-


