
Máy In 3D
Vỏ điện tử trước cho Ender-3 V2 và hộp Raspberry Pi
Remix of Ender-3 V2 Front Electronics Housing By pedrolamas
- Downloads
- 198
- Likes
- 62
- Views
- 1,846
- Remixes
- 2
- Comments
- 8
Files 5 34.1 MB
- left_top_1765639031.stlSTL · 36.8 KB
- right_top_1765639032.stlSTL · 216.9 KB
- left_bottom_1765639033.stlSTL · 159.9 KB
- right_bottom_pi90_1765639034.stlSTL · 122.3 KB
Make a variant with AI
Build another version of this model.
Remix versions 2
Hộp Điện Tử Mặt Trước Ender 3 v2 Cập Nhật MớiByN_F_B · 12/03/2025
Vỏ điện tử phía trước cho máy in 3D Ender-3 V2Bykilinccagatay · 03/29/2025
Details
- Model ID
- #46045
- Category
- Máy In 3D
- Published
Description
New updated model here!
----
This is a remix from user @Pedrolamas
What I noticed right away was that the back screws used to secure the top are in an akward position.
They either didn't line up, or were barely reachable. I ended up just using the front screws and leaving the back screws out.
What I changed:
- Changed the back screw design to a slide system. There are no more screws in the back.
- Added another fan cutout to the right side for the Raspberry Pi.
- Turned the position for the Raspberry Pi 90 degrees.
- Made a cutout on the left and right top guides, to accommodate for the fan so the top can sit flush.
- Made a cutout for the Z-axsis and Z end switch wires to go to the motherboard.
- Reinforced the back for more rigidity.
- Reinforced the front for more rigidity.
- Moved the fan position to accommodate for the micro usb port on the motherboard.
Printing:
Make sure that the top pieces are turned around 180 degrees.
- Resolution: 0.2
- Infill: 20%
- Generate Support: checked
- Support Structure: Tree
- Support Overhang Angle: 50.0
Print time aprox. 28.5 hours
Print spec
- Formats
- stepstl
- Model files
- 5
- Total size
- 34.1 MB
- Largest file
- 33.6 MB
8 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-

-

-


