Skip to main content
F3D
Giá đỡ cho bàn phím và bàn di chuột Apple Magic 1

5 images

Dụng Cụ Tiện Ích

Giá đỡ cho bàn phím và bàn di chuột Apple Magic

By tpc_516603

Downloads
48
Likes
10
Views
837
Comments
1

Files 1 429.6 KB

  • Apple_keys_and_trackpad_sleeve_1767249193.stlSTL · 429.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a quick designed holster to keep my Apple Keyboard and trackpad in when I travel. It fits in a bag or in my flight case and stops the trackpad mostly from getting damaged or cracked during transport. You need to orientate the trackpad and Keys to fit in the correct way so the power switch on the back of either is outside of the box - but that's the only gotcha!

Have put a small cutout into both sides for the little rubber feet on the underside.

Printed this upright (so I got a reasonably good side finish) with no supports, a minimal brim and 10% infill and cubic subdivision pattern. Needed it quickly!

Could be attached to a wall or inside of a back with some sticky-back pads/velcro hooks. Will probably print another to velcro to my flight-case lid!

Just realised it should also fit two keyboards or two trackpads… I shall take a photo when I get another set to test with. It will also work with the number pad longer version of the keyboard too.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
429.6 KB
Largest file
429.6 KB

1 comment

See all