Skip to main content
F3D
Giá đỡ bật lửa BIC EZ Reach cho QUICK-CLIP v3 1

3 images

DIY

Giá đỡ bật lửa BIC EZ Reach cho QUICK-CLIP v3

By TaylorSteinf_1252185

Downloads
320
Likes
104
Views
1,499
Comments
1

Files 1 417 KB

  • QUICK-CLIP_-_BIC_EZ_Reach_Lighter_Module_1766340291.stlSTL · 417 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

NOTE:This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"

Post-Processing Difficulty:Medium

Tools Needed: Needle Files or Fingernail Files, Side Cutter, Deburring Tool, etc.

Introduction & Instructions:

QuickClip is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a tourniquet holster module that I designed to go with the base starter set (found under my profile). This case is designed to accommodate the storage of a BIC EZ Reach Lighter (It MAY fit a standard BIC Lighter, but I have not tested it yet - I wanted more distance between the plastic and the flame, so I used the EZ Reach version). To use the lighter, the entire module may be removed, or the lighter may be removed from the module. Optionally, you may also use a small amount of superglue inside to permanently secure the lighter to the module. Note: The plastic sticker/decal needs to be removed from the lighter first before inserting it into the module. When complete, this module is attached to and removed from the mounting system in the same way as the other module clips. The base buckle (black) files are available in the base starter set.

I printed this with 0.16mm layer lines with PLA with organic/tree supports This design must be printed on a side position. The clip interface on the back will need minor post-processing with a needle file or sandpaper to remove leftover support material and to allow the clip and buckle to interlock smoothly.

Post-Processing:

There will be some support structures to remove. The supports from the clip will need to be removed with a side cutters and refined using minor filing or sanding to make sure they attach to the buckles smoothly. The edges of the ‘window’ may be rough from leftover supports and can be refined using sandpaper or with a deburring tool.

Hope you enjoy!

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
417 KB
Largest file
417 KB

1 comment

See all