
Bộ lưu trữ băng keo cho QUICK-CLIP v3
- Downloads
- 423
- Likes
- 139
- Views
- 2,097
- Remixes
- 0
- Comments
- 12
Files 1 269 KB
- QUICK-CLIP_-_DUCT_Tape_Wrap_Module_1766157053.stlSTL · 269 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #43321
- Category
- DIY
- Published
Description
NOTE:This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"
Post-Processing Difficulty:Easy (Ready to Use from Printer)
Tools Needed: None
Introduction & Instructions:
QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a duct tape storage wrap / winder module that I designed to go with the base starter set (found under my profile). This module allows for easy access to your items and is attached to and removed from the mounting system in the same way as the other module clips. The locking pin (orange) and base buckle (dark gray) files are available in the base starter set.
I printed these with 0.16mm layer lines with PLA with no supports or brims. Simply wrap the duct tape around the winder to your desired amount!
Hope you enjoy!
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 269 KB
- Largest file
- 269 KB
12 comments
You may also like 12 models
See all-

-
New -
New -

-

-

-

-

-
New -

-
New -


