
ESP32 CYD "Halehound" Modular Multi-Tool Case (GPS/NFC/RF)
- Downloads
- 154
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 7 21 MB
- 1_front_plate.stlSTL · 2.4 MB
- 2_Mid_board_frame.stlSTL · 3 MB
- 3_mid_frame.stlSTL · 3.5 MB
- 4_battery_case.stlSTL · 8 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #419261
- Category
- DIY
- Published
Description
This is a custom-designed, modular multi-layer case for the "Cheap Yellow Display" (ESP32-2432S028) running the Hellhound firmware. The design focuses on ease of assembly, durability, and a clean layout for multiple radio modules.
The multi-layer structure allows you to print and replace individual sections if you decide to modify your hardware setup, without needing to reprint the entire shell.
Key Features:
Triple Antenna Setup: Dedicated mounts for ESP32, NRF24L01, and E07-433M20S using SMA-KY pigtails.
High Capacity Power: Designed to fit a standard dual 18650 battery holder (parallel connection) for extended runtime.
User Controls: Front-facing Boot and Reset buttons with a dedicated power switch in between.
Port Protection: Bottom ports are protected by a removable cover secured with M2 screws.
Bill of Materials (BOM):
MCU: ESP32-2432S028 (Cheap Yellow Display)
RF Modules: NRF24L01+PA+LNA, PN532 V3 (NFC), GPS NEO-6M
Optional: Provision for E07-433M20S module
Power: Mini DC-DC Step-Up Converter, Li-ion USB-C charging board
Connectors: 3x IPX to SMA-KY Pigtails (M8 nut)
Hardware: M2x4 and M2x6 screws
Printing Settings:
Material: PETG (Translucent Red and White recommended for the "Halehound" look)
Infill: 15%
Supports: None (designed to be printed without supports)
Orientation: Print parts horizontally for maximum structural strength.
Software: Compatible with the Hellhound firmware. https://github.com/JesseCHale/HaleHound-CYD
Print spec
- Formats
- stl
- Model files
- 7
- Total size
- 21 MB
- Largest file
- 8 MB
0 comments
You may also like 12 models
See all-

-
New -
New -

-

-

-

-

-
New -

-

-


