Vỏ Raspberry Pi 5 cho Dashcam tích hợp GPS

A purpose-built enclosure for turning a Raspberry Pi 5 into a compact, mountable dashcam. Designed for continuous recording of GPS-tagged video, this case integrates a camera module, GPS receiver, and a small onboard OLED-display into a functional housing.

Software

The software to run this dashcam will be available open source and on GitHub soon. Feel free to check it out, fork it, report issues, or contribute improvements. Setup instructions and dependencies will be documented in the repository's README.

Hardware

1x    SD card
1x    Raspberry Pi 5
1x    Camera Module 3
1x    8 cm CSI camera cable
1x    Waveshare LC29H (AA)
1x    128 x 128 px OLED display
1x    12 x 12 mm momentary switch
1x    1/4-20 threaded insert
6x   Female to female jumper wires
13x  M2 x 2.5 x 3.2 threaded inserts

Print

• It's recommended to print this case in PETG, as interior temperatures under a windshield can exceed 60–70°C in direct sun. PLA will soften and deform under these conditions.

• For clean results, print with supports enabled and a 30-degree overhang threshold, because some of the side ports have overhanging geometry that will otherwise print in mid-air without support.

Assembly

Coming soon.