ExoBass - Bộ phận cánh - Hipbone

Part of the ExoBass project — full catalog, build planner, and assembly guides at https://exobass.com

Plan Your Build & Get Hardware

ExoBass can be confusing! Head over to our build planner to plan your entire build - it'll walk you through every available part and handle compatibility along the way, and it covers all ExoBass parts. It's also the best way to get hardware, since it lets you buy everything for a full build in one go, not just this part.

You can find this specific part, ExoBass - Wing Sets - Hipbone, on our site.

Step 1: Heat set inserts

Step 1a: Insert strap mount heat set inserts

Step 1b: Insert pickup mount heat set inserts

ℹ️ This is optional, if you don't want to use the Over String Pickup Mount or the Lace Ultra Thin Pickup you can skip this step.

Step 2: Glue body together

Using super glue, put all of the body pieces together.

ℹ️ You will need to squeeze the sides in in order for this to pop into place.

Step 3: Glue in Control Panel

Step 4: Control Panel Electronics

Step 5: Attach to Core

Step 6: Strap Mounts

Step 7: Install Pickup

• Install Ultra Thin Lace Pickup
• Install Over String Pickup Mount

Hardware

DIY Kit

You can order a DIY kit for your entire build from our build planner, the estimate for this part's kit is $8.68 plus shipping.

Self Source

If you want to order the parts yourself, here's a list. Estimated cost: $75.98.

• 12x Screw - Button Head - M5x10
• 12x Nut - Slide In - M5
• 2x Heat Set Insert - M3 - 4.8mm OD - 4.6mm L - Flanged
• 10x Screw - Flat Head - M3x10
• 10x Screw - Flat Head - M3x20
• 20x Heat Set Insert - M3 - 5mm OD - 4mm L
• 2x Strap Buttons
• 1x Jack - Output - Mono 1/4in