Mô hình trang trí Logo Dio (Dio Name Logo)

Like a rainbow in the dark! This model is part of my Slave To The Metal 90s Drawing Series /Collection, where I am systematically turning my original hand-drawn concept art of classic band logos into clean, printable display pieces.

This plaque captures the iconic, ornate gothic typography of Dio in sharp 3D detail. To preserve the intricate swirls and floating line elements of the original artwork while guaranteeing structural strength, this model features a contoured Base backing plate that ties all the intricate lettering together perfectly.

Equipped with (2) built-in keyhole slots on the back, this piece hangs completely flush against your wall using screws or nails. At roughly 8 inches wide, it’s an effortless, single-piece print for standard bed sizes.

Multi-Color Filament Swapping Tip:

1. To get that classic high-contrast look (as shown in the red and black render):

2. Slice the model flat on its back.

3. Print the base plate layer in a dark color (like Black or Charcoal).

4. Program a single filament swap right where the raised letters begin to switch to a vibrant accent color (like Red, Gold, or Silver)!

Dimensions

• Text Width: 7.7”

• Text Height: 3.71”

• Text Thickness: 0.4375”

• Base Width: 8.0665”

• Base Height: 4.1778”

• Base Thickness: 0.0625”

• Total Thickness: 0.5”

• Mounting: Features (2) built-in key-hole slots on the back of the base variant for easy hanging with #3 screws or nails.

Print Settings

• Material: PLA

• Layer Height: 0.12mm to 0.20mm (Lower layer heights yield incredibly smooth results across the blocky angles of the letters).

• Infill: 10% or higher (Gyroid or Grid patterns work beautifully for stability).

• Supports: None required when printed flat on the bed.

Where It All Began:

Curious about the original hand-drawn concept art that inspired this whole series? Check out the model that started it all: