Đế sạc cho laptop Framework 13

A simple charging stand for the Framework 13 laptop 

Hardware

• 1 x UGREEN Cable (Ugreen US286)

• 1 x M3 x 20 screw to secure cable

• Rice

Printing Instructions

I used PLA, but PETG should work fine.

No supports necessary

Add a pause before the cavity inside the 'wings' closes over so you can pour in some rice or something similar to add some weight to your base.

Assembly Instructions

Push the plug in through the bottom, slide your laptop into place and make sure the cable is properly seated, then add the M3 screw to the back and tighten it down to hold the cable in place.

The plug is a very tight fit, you may need to scrape away some of the rubberised coating to get it in there, but it should fit!