Đèn lồng/Bộ khuếch tán F8B

Ever wanted to burn the retinas of everyone in the room? Introducing the DDH-F8B lantern!

Inspired by @spicy3d's diffuser designs. 

Printed using clear PETG in two parts. f8bDiffuserBody was printed upside down, with the wider opening to the build plate. Supports on build plate only were used to support the center column. A 10mm brim was enabled for improved stability. 

The cap should be printed wide side down, supports and brim aren't necessary. 

Aluminum tape was applied to the inside of the cap to improve lateral light output. 

The diffuser is intentionally a relatively loose fit, but feel free to scale down slightly if you prefer a more solid fit. 

Disclaimer: I am not responsible for damage to your flashlight, yourself, anyone else, or anything else resulting from the use of this model. It has survived a 5 second turbo blast attached to mine, but ymmv due to filament/led/tolerance differences. 

*flashlight not included