Skip to main content
F3D
Miata Knee Panel - Tấm ốp đầu gối cho Mazda Miata NA8 1

3 images

DIY

Miata Knee Panel - Tấm ốp đầu gối cho Mazda Miata NA8

By 3D_World

Downloads
3
Likes
1
Views
30

Files 2 5.8 MB

  • NA8_KneePanel_1784617803.stlSTL · 5.6 MB
  • KneePanelScrewMounts_1784617804.stlSTL · 171.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#414318
Category
DIY
Published
Tags

Description

My 97 NA Miata did not have this panel at all, I assume it was removed by some previous owner and it was lost, so I wanted to make one. There's a lot of iteration in this design, and it fits pretty well. I did not have the original, so to my eye it looks good, but things can always be improved. I printed it in PCTG with perlin fuzzy skin on the outside face so that it matches (somewhat) the interior texture. PCTG was also too shiny, so I sprayed it in plasti-dip to dull it. 

I didn't follow the stock mounting method of clips, either, I used some m5x16 SEMS screws to mount it. You'll need 4 of them. Get black ones or paint them, and you'll probably not notice them. The holes do have to be pre-drilled on the upper locations though closer to the steering wheel.  I may make a clip version in the future. 

It needs to be printed as shown, with painted on supports. It's possible it could be printed standing on the thin edge, but you'd need a very large brim. breakaway supports would of course be best.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
5.8 MB
Largest file
5.6 MB

0 comments

See all