Mô hình Ván trượt (Skateboard) để bàn

Assembly Steps

Step 1: Install the Front Mounting Block

Locate the mounting holes on the underside of the skateboard deck. Align the screw holes of the first mounting block with the corresponding holes on the front underside of the deck. Insert the hardware screws through the mount and tighten them securely into the deck until the mounting block is flush and locked in place.

Step 2: Insert the Front Axle Cylinder

Take one of the cylindrical axle pins and slide it directly through the center bore of the newly installed front mounting block. Center the cylinder so that an equal amount of the axle protrudes from both sides of the mount.

Step 3: Attach the Front Wheels

Slide one wheel onto the left exposed side of the axle cylinder, and the second wheel onto the right side. Ensure the wheels are pushed on securely and sit flush to keep the model beautifully stationary for display without sliding.

Step 4: Repeat for the Rear Assembly

Turn the board around and repeat the exact same process for the back side:

1. Align and screw the second mounting block to the rear of the deck.

2. Slide the remaining axle cylinder through the rear mount's bore.

3. Push the final two wheels onto either side of the rear axle to complete the static display piece.